top of page
about IRINGO Blocks
IRINGO Assembly TIP
TIP1. Let me tell you how to easily separate LU or HU blocks.
If you try to separate them holding the center of block 2, like Fig A, it is not easy.
But as shown in Fig B, if holding the corner of block 2 and bend and pull, you can separate them easily. As shown in Fig C, if you should separate two blocks, take hold the tail of block 2.
TIP2. Are you difficult to grip on a LT block, when you separate HU and LT blocks?
As shown in Fig A, when you try to separate HU and LT blocks, you would be difficult to grip on the LT block. As shown in Fig B, connect the other HU block to the LT block which is difficult to grip on. And then you can more hold easily it.
TIP3. Let me tell you how to easily remove a ST block that is caught in a DR block.
As shown in Fig A, please press the ST block by the tail of LU (or HU) block.
You can see the ST block stick out of the DR block slightly, like Fig B.
TIP4. After wheel blocks (LW and DR blocks) has been assembled, they shouldn't separate.
When separating wheel blocks that are assembled, the blocks can get broken or your hand can get hurt. Please use the completed wheel as it is.
TIP5. If your works need the Ringo Trio(BT, BY, BU blocks), please assemble the Ringo Trio first.
As shown in Fig A, if the Ringo Trio is not all connected, it will be troublesome for connecting other blocks together. Please connect the other blocks after assembling all Ringo Trio blocks first, as shown in Fig B. It will be better.
TIP6. It is difficult to separate HU (or LU) block out of a TU block by bare hand.
As shown in Fig B, please press a HU(or LU) block using the other HU(or LU) block.
IRINGO CO.LTD | CEO. HEO IN DEOK | Company Registration Number. 137-81-74026 | e-mail. firstname.lastname@example.org
Address. 140, Namdongdong-ro, Namdong-gu, Incheon, Republic of Korea
The contents of this site are protected by copyright law, and reprint without permission, copying, distributing, etc. are prohibited.
bottom of page